Schrijver
| No enough memory on a Sunrise CF
|
Atheus
msx novice
Berichten: 26 |  Geplaatst: 02 September 2007, 12:37 |
I got a Panasonic A1GT and a Sunrise CF IDE (since a few days).
After booting with my Sunrise CF, I always have the "No Enough Memory" message...
After reading some threads on this forum, I tried to start my computer pressing <DEL> on startup to boot from the Sunrise floppydisk ... Then I launched FDISK 3.10 software to create partitions and to format all of them.
At the FDISK menu, only have :
[T]oggle drive
[E]xtended drive info
and
[Q]uit
But problem : Keyboard is locked ... Impossible to do anything ...
Thx for your help !
|
|
Sd-Snatcher
msx freak
Berichten: 255 | Geplaatst: 02 September 2007, 15:26 |
The no enough memory is because MSX loads PC code from boot in CF card.
Only 3 options... too few, you can see the card model in the upper of screen?
Which cf card do you use?
|
|
Atheus
msx novice
Berichten: 26 | Geplaatst: 02 September 2007, 18:16 |
I tried with 3 compact flash models ...
- Kodak 32 Mo
- Verbatim 128 Mo
- Kingston 512 Mo
And I always have the "No enough memory" message OR the keyboard locking under Fdisk (after a pressing <DEL> at startup) ...
|
|
Atheus
msx novice
Berichten: 26 | Geplaatst: 02 September 2007, 18:27 |
and YES, i can read the CF Models in the upper of screen (DeviceName = CHH 128M, or anything else for the others)
|
|
Jipe
msx freak
Berichten: 195 | Geplaatst: 02 September 2007, 19:54 |
you insert CF in the bad connector
insert two CF in the IDE CF
[T]oggle swap CF1 CF2
you can read the CF Model and change it
you can format with the command menu
|
|
Atheus
msx novice
Berichten: 26 | Geplaatst: 03 September 2007, 08:18 |
Merci Jipe 
But how can I insert CF in the bad connector ???
I tried yesterday evening to insert an other CF at the same time and no way ...
I tried with an other CF (a fourth CF 64M) ; and always the same problem.
I just received this Sunrise Compact Flash IDE dew days ago, and I think it's broken ... |
|
QuinnTheEskimo
msx user
Berichten: 37 | Geplaatst: 03 September 2007, 14:24 |
If it's broken and only a few days old perhaps you should return it for service.
|
|
Jipe
msx freak
Berichten: 195 | Geplaatst: 03 September 2007, 14:36 |
the CF have a Master and a Slave connector : put one CF in master
have you try re-flash the Bios inside the cartridge with IDEFLOAD.COM ?
|
|
Atheus
msx novice
Berichten: 26 | Geplaatst: 03 September 2007, 16:09 |
Yes, I always upgraded my CF again with the IDE240 ... without any problem ...
And for the suggestion about slave and master, of course, i tried to change position of my CF cards.
|
|
|
|
|
